BakersfieldEle
BakersfieldMicThe counterweight guide rail should meet the specification requirements.
Emergency manual valve: In case of power failure, it can cause the car to descend to the nearest floor position and open the door
Bakersfield.The counterweight steel wire rope should be equipped with an anti loosening device that is sensitive and reliable.
Before installation, embedded parts,BakersfieldPure electric curved arm elevator, and foundation drainage measures of the installed construction electric elevator and auxiliary heavy equipment comply with the requirements of the special construction plan for the installation and dismantling of the construction electric elevator based on the construction electric elevator foundation acceptance form, concealed engineering acceptance form, and concrete strength report.
.Speed limit wire rope switch. When the speed limit wire rope trips or breaks. Make the electric elevator unable to start.
Construction electric elevators outside the lightning protection range
Drainage measures need to be considered around the foundation. (Drain the accumulated water on the foundation).
The safety bulletin board for construction electric elevators should be hung at the protective shed of the electric elevator, with a size of 8 meters by 2 meters.
Folding arm electric elevators are mostly driven by hydraulic means,BakersfieldElectric scissor lift, and the source of power for the hydraulic system is hydraulic oil. Only when the hydraulic oil quantity is sufficient and the oil quality is high, can the folding arm electric elevator provide greater torque output, thereby improving work efficiency. So, how can we determine whether the newly added hydraulic oil quantity is sufficient? What is the hydraulic oil quantity standard?
Drivers of construction electric elevators should hold special construction operations and are not allowed to operate without a certificate.
Honest service.Mechanical devices controlled by cage movement should not be used to open or close the landing door.
When the wall bracket cannot meet the requirements of the construction site, it should be designed and calculated separately.
The bearing capacity of the building structure at the attachment point of the wall bracket should meet the requirements specified in the user manual for construction electric elevators.
The bearing capacity of the building structure at the attachment point of the wall bracket should meet the requirements specified in the user manual for construction electric elevators.
How much is it.Human improper operation is the main factor causing malfunctions in scissor type electric elevators. When stacking goods, electric elevators should stack the goods neatly, which is better than stacking them in the center of the cargo stacking area of the cargo elevator to avoid imbalance between the two ends of the stacking area. Eventually, during the operation of the electric elevator, it may cause the electric elevator to lose balance. After the goods are stacked completely, ropes should be used to lock the goods,BakersfieldSmall electric elevator platform, so that they are not afraid of the goods during the lifting process; Careless; Scattered down
The use of fully autonomous electric elevators can create more benefits and ensure safety in all aspects.
When the wall bracket cannot meet the requirements of the construction site, it should be designed and calculated separately.
Bakersfield.Speed limit wire rope switch. When the speed limit wire rope trips or breaks. Make the electric elevator unable to start.
The bearing capacity of the building structure at the attachment point of the wall bracket should meet the requirements specified in the user manual for construction electric elevators.
There is no need to set up a computer room above the shaft like an elevator, and the top floor height can be installed at least 2.5 meters.