peace6-12 mete
peaceSmall eleDuring loading and unloading,peaceFully electric scissor lift,peaceScissor fork electric elevator, the horizontal distance between the edge of the cage door and the edge of the landing station should not exceed 50mm.
Setting requirements: The landing door should be standardized and tooled.
peace.Setting requirements: Construction electric elevators should be equipped with a down travel (limit) switch. The down travel (limit) switch should be able to automatically stop the cage running at rated speed before reaching the lower limit switch.
Setting requirements: The foundation and foundation of the construction electric elevator should meet the requirements of the user manual. Before installing the construction electric elevator, the foundation should be inspected and accepted according to the requirements of the specifications. Only after passing the inspection can the installation be carried out.
.Setting requirements: The layout and installation of all cables and wiring of electric elevators should be able to prevent mechanical damage.
The L distance depends on the selected wall mount model.
The use of a lifting platform as a tool for storing performance blankets, soft scenery, etc. In some theaters, there is a soft scenery storage lifting platform located at an appropriate location on the stage for the storage of blankets, soft scenery, etc.
The landing door should meet the requirements of the specifications and achieve standardization.
Alarm devices can be divided into fixed and mobile platforms, rail type and scissor type (curved arm type) to distinguish between overload or equipment malfunction. Fixed types include: scissor lift cargo elevator, chain electric elevator, and installation
The distance between the electric hoist and overhead line in Electrical safety construction shall meet the specification requirements, otherwise protective measures shall be taken.
Meticulous workmanship.Protective measures should comply with regulatory requirements.
Setting requirements: The foundation and foundation of the construction electric elevator should meet the requirements of the user manual. Before installing the construction electric elevator,peaceElectric elevator, the foundation should be inspected and accepted according to the requirements of the specifications. Only after passing the inspection can the installation be carried out.
Emergency manual valve: In case of power failure, it can cause the car to descend to the nearest floor position and open the door
It is reported that a fixed electric elevator has good lifting stability and can only be used for fixed operations, making high-altitude operations easier
Product range.Principle of electric elevator rotary valve: When the electric elevator rises, the rotary valve will automatically open. To close the plug valve, it is necessary to first turn the handle to turn the plug to a 90 degree position until it is closed, and then turn the transmission handwheel to lower the plug and achieve sealing.
The top of the hanging cage is accessible; d) During installation/disassembly/maintenance/inspection of the device; e) Inside the hanging cage.
The landing door should be in a normally closed state. Without the permission of the construction electric elevator driver, the landing door shall not be opened.
peace.The foundation production and acceptance of electric elevators for foundation construction should comply with the user manual and regulatory requirements.
The foundation production and acceptance of electric elevators for foundation construction should comply with the user manual and regulatory requirements.
The bearing capacity of the ground under the concrete foundation plate should be greater than 0.15Mpa.