Baja Simple el
Baja Electric Flat screw mechanical electric lifting mechanism: The lifting platform of this structure has the advantages of small civil engineering coordination, shallow foundation pit required, large stroke, stable operation, accurate positioning, and low cost. Adopting a horizontal screw drive and a scissor fork structure to achieve the lifting motion of the table, it can be stopped arbitrarily within the range of travel.
Horizontal lead screw mechanical electricity
Baja .Before use, we should observe whether there is any damage to the electric elevator. We can conduct a no-load test to raise and lower it. If there are any damaged parts, they should be replaced in a timely manner to prevent major accidents.
High lifting height, using side mounted oil cylinders,Baja Electric tatami elevator, stable operation, noise free,Baja Mobile electric elevator, easy maintenance, and longer service life.
.Steel wire ropes, pulleys, and counterweight steel wire ropes shall comply with the following regulations: the characteristics of steel wire ropes shall comply with the requirements of General Purpose Steel Wire Ropes GB/T20118; Maintenance,Baja Elevator manufacturer's electric elevator, wear, deformation, and corrosion of steel wire ropes
Construction electric elevators should be equipped with cable guide frames and comply with regulatory requirements.
Implementing multiple shifts of homework should fill in and submit records according to regulations.
Horizontal lead screw mechanical electricity
After the limit switch is activated, only professional personnel can restore the movement of the suspension cage.
Tank oil temperature protection: When the oil temperature in the tank exceeds the standard setting value, the oil temperature protection device sends a signal to suspend the use of the elevator. The elevator can only be started when the oil temperature drops
Range.Setting requirements: The anti loosening and anti loosening parts between the connecting parts should comply with the provisions of the user manual and should not be replaced by other objects. For connecting bolts with pre tightening requirements, a torque wrench or special tool should be used to accurately tighten the bolts to the specified torque value according to the specified tightening sequence. When installing standard section connecting bolts, it is advisable to place the screw at the bottom and the nut at the top.
The end height of the guide rail frame above the high attachment point should comply with the provisions of the user manual.
The foundation base or embedded parts should be fully embedded in the concrete foundation plate.
When the horizontal distance between the edge of the cage and the edge of the landing or between the cage and the landing door is greater than 150mm and there is no effective protection from other structures, the side protection device for the landing entrance should be equipped.
technical service.Setting requirements: The installation and dismantling workers, electricians, and other operators of construction electric elevators should have special construction operations.
Fully autonomous lifting is widely used in various high-altitude work fields, such as factory maintenance, airport maintenance, street light maintenance, and so on; How to use electric elevators correctly to extend the service life of the equipment and be flexible
Setting requirements: Drainage measures should be set up for the foundation of construction electric elevators to ensure smooth drainage.
Baja .The function of the lifting platform in a theater is roughly as follows: the main lifting platform arranged in the main performance area of the stage is mainly used to quickly change the scenery. Typically, side car platform the lifting platform, and rear car turntable perform a rapid transformation of the entire or partial scene. This arrangement allows for rapid switching of three full sets.
In addition to ground protective fences, low level doors can be used. Low level doors should meet the following requirements: the height of the door should be between 1m and 2m. And there should be at least protective railings a half height middle crossbar, and a toe board at least 150mm above the ground.
Setting requirements: The landing door should be standardized and tooled.