ColumbusElectr
ColumbusTatami
ColumbusElectrColumbusElectric passenger lift, the landing door shall not be opened.
Drivers of construction electric elevators should hold special construction operations and are not allowed to operate without a certificate.
Columbus.After the limit switch is activated
The landing door should be in a normally closed state. Without the permission of the construction electric elevator driver, only professional personnel can restore the movement of the suspension cage.
Tank oil temperature protection: When the oil temperature in the tank exceeds the standard setting value,ColumbusElectric fork lift table, the oil temperature protection device sends a signal to suspend the use of the elevator. The elevator can only be started when the oil temperature drops
.Braking. The brake limit switch for partial motion control of the electric hoist traction machine. Assembly that restricts the operation of the lift car when it is opened to a high or low position; If the limit switch controls the overtravel switch. When the car travels to a high or low position, stage equipment should be dismantled with over travel switches that can cut off power and cannot be automatically reset, and installed in the machine room, rather than in the shaft; A buffer should be installed that can absorb the energy of the moving mechanism and reduce impact.
There is no need to set up a computer room above the shaft like an elevator and the top floor height can be installed at least 2.5 meters.
It is reported that a fixed electric elevator has good lifting stability and can only be used for fixed operations, making high-altitude operations easier
Setting requirements: The foundation and foundation of the construction electric elevator should meet the requirements of the user manual. Before installing the construction electric elevator, the foundation should be inspected and accepted according to the requirements of the specifications. Only after passing the inspection can the installation be carried out.
Before installing the construction electric elevator, the foundation should be inspected and approved before installation.
The spacing between wall brackets and the height of guide rails above the high attachment point should comply with the requirements of the user manual.
Honest management.It is reported that a fixed electric elevator has good lifting stability and can only be used for fixed operations, making high-altitude operations easier
The use of standard section connecting bolts should comply with the user manual and specification requirements.
During normal operation, the horizontal distance between the closed cage door and the closed landing door should not exceed 150mm. Otherwise, measures should be taken to make it meet the requirements, or side protection devices at the entrance of the landing station that meet the requirements should be equipped. The distance between any opening between the side protection device and the hanging cage or landing door should not exceed 150mm.
Drivers of construction electric elevators should hold special construction operations and are not allowed to operate without a certificate.
Manufacturing cost.Setting requirements: The verticality deviation of the installation of the guide rail frame of the construction electric elevator should comply with the requirements of the user manual and specifications, as specified in the above table.
Before each shift of work, the safety devices of the construction electric elevator should be inspected to ensure sensitivity and reliability.
Vertical lead screw electric lifting mechanism: Adopting a lead screw transmission method,ColumbusBackground axis electric elevator, it can achieve the lifting of a double-layer tabletop. Multiple lifting platforms can be formed as needed, and different steps can be formed within the travel range to meet the needs of meetings and performances; Pavilion, Terrace, Tower, making high-altitude operations easier
Installation and dismantling personnel and drivers should hold certificates to work.