Lumia Electric
Lumia Fixed elLumia Pure electric curved arm elevator,
Setting requirements: Drainage measures should be set up for the foundation of construction electric elevators to ensure smooth drainage.
Braking. The brake limit switch for partial motion control of the electric hoist traction machine. Assembly that restricts the operation of the lift car when it is opened to a high or low position; If the limit switch controls the overtravel switch. When the car travels to a high or low position, it will take on the function of raising or lowering. In order to prevent the lift car from crashing or sinking, stage equipment should be dismantled with over travel switches that can cut off power and cannot be automatically reset, and installed in the machine room, rather than in the shaft; A buffer should be installed that can absorb the energy of the moving mechanism and reduce impact.
Lumia .The usual operation of landing and docking. The installation position of the upper limit switch should comply with the following: when the lifting speed is less than 0.8m/s,Lumia Four meter electric elevator, the upper safety distance L left after the upper limit switch is triggered by the hanging cage should not be less than
Setting requirements: The spacing of wall brackets along the vertical direction should comply with the provisions of the user manual.
.Especially suitable for steel structured factories, suitable for both indoor and outdoor installation.
The bearing capacity of the ground under the concrete foundation plate should be greater than 0.15Mpa.
The pump body adopts an integrated pump station, all equipped with imported high-quality pump stations, which can also be selected according to customer requirements to meet customer ideal requirements.
According to the needs of different performance genres, the form of the stage can be changed. For example, using an orchestra pit lift can combine a framed stage with a large lip or even an extended stage. In an experimental theater, using a lift can make the theater have various forms such as an end stage, an extended stage, a T-shaped stage, or a hall.
The counterweight steel wire rope should be equipped with an anti loosening device that is sensitive and reliable.
Installation and dismantling personnel and drivers should hold certificates to work.
A complete range of products.Safety performance: Electric elevators not only have the safety device of traditional traction elevators, but also have an overflow valve to prevent excessive system pressure during upward movement
When the horizontal distance between the edge of the cage and the edge of the landing or between the cage and the landing door is greater than 150mm and there is no effective protection from other structures, the side protection device for the landing entrance should be equipped.
The safety distance between the outer edge of the upper part of the landing door and the moving parts of the electric elevator during normal operation should not be less than 0.75m; If the rated speed is not greater than 0.7m/s, the safety distance can be 0.40m.
Setting requirements: The guide rail should be rigid and flexible components such as wire ropes or chains should not be used.
Energy costs.The angle between the wall bracket and the horizontal plane should comply with the requirements of the user manual.
Construction electric elevators should be equipped with travel limit switches, as follows: automatic reset type upper and lower limit switches should be installed on construction electric elevators, but the upper and lower limit switches should not be triggered as high
Speed limiter. To prevent the driving speed from exceeding the normal speed. A speedometer should be installed (not required for floors below or including the second floor), which is an individual mechanism that is integrated with a safety clamp; The entrance and exit of the passenger compartment should be equipped with safety doors. Public places family dormitories, and
Lumia .The bearing capacity of the ground under the concrete foundation plate should be greater than 0.15Mpa.
High lifting height, using side mounted oil cylinders, stable operation, noise free, easy maintenance, and longer service life.
The wall bracket of the construction electric elevator should be intact and reliably fixed, and its attachment distance,Lumia 6-meter electric elevator, wall bracket spacing, and end height must comply with the requirements of the 'User Manual'. The angle between the plane of the wall bracket and the normal direction of the attachment surface should not exceed 8 degrees;. When the attachment device does not meet the requirements of the 'User Manual' due to conditions, its calculation sheet design, and production materials should be confirmed by the manufacturer or reviewed by the technical leader of the installation unit, and verified by experts.