DusseldorfHydr
DusseldorfFixewe should listen for any abnormal noise. If there is any abnormal noise
Website homepage
When using the elevator, we should immediately stop using it to avoid serious damage to the elevator.
Dusseldorf.Of course, the hydraulic lifting platform uses a dual protection structure, an appropriate working surface can be selected, so that the lifting platform will be safer during operation. The process of operating the hydraulic lifting platform should be standardized,DusseldorfHydraulic lifting platform automatic, so that maintenance and debugging can be carried out before leaving the factory. At the same time, it can also ensure that all technical indicators can meet the design requirements, but it is necessary to connect the ground wire during use. Of course, the hydraulic electrical system does not need to be adjusted in this situation.
The lifting stage can achieve the lifting of a double-layer tabletop. It can also be pieced into a stepped, multi scenic, and multi-level staircase as needed,
.When working at heights exceeding 1.5 meters, safety nets or safety belts must be used.
Firstly, an obvious advantage is its high safety performance. The guide rail hydraulic lifting platform adopts heavy-duty chain transmission, hydraulic explosion-proof oil pipes, multiple limit switch protection, door and power outage protection, leakage protection,DusseldorfMobile hydraulic loading and unloading platform,DusseldorfHydraulic lifting platform for loading, and multi-layer building interaction. Therefore, the safety factor of the guide rail hydraulic lifting platform is still very high, much higher than that of ordinary platforms.
The elevator has undergone strict testing before leaving the factory. If the pressure regulating valve is adjusted arbitrarily by non manufacturers, it may cause abnormal system operation. Non professionals should not adjust the pressure regulating valve arbitrarily!
Later, when there is a major malfunction of the lifting platform, it should be repaired by professional personnel as soon as possible. After the malfunction occurs, it should not be used again to avoid accidents, personnel and property losses.
When using a hydraulic lifting cargo elevator, it is necessary to have corresponding inspection routes. If the route malfunctions and the joint becomes loose, it is necessary to turn it on or off properly. In this case, there may be short lines or damaged components. Using a table for inspection is relatively better.
The elevator has undergone strict testing before leaving the factory. If the pressure regulating valve is adjusted arbitrarily by non manufacturers, it may cause abnormal system operation. Non professionals should not adjust the pressure regulating valve arbitrarily!
Sales Department.Outdoor elevators and factory cargo elevators are heavy lifting mechanical equipment. Outdoor elevators are used for transporting goods between floors of buildings, and are specialized hydraulic cargo elevator products. They are mainly used for transporting goods up and down between various working floors; Vertical garage and car lift between garage floors. The hydraulic system of the product is equipped with anti fall and overload protection devices, and operation buttons can be set on each floor and lifting platform workbench to achieve multi-point operation.
Replace with
Remove and disassemble the lowering valve, blow the valve core clean with compressed air, and then reinstall it.
When the motor overheats it should be stopped immediately, and after troubleshooting, it should continue to operate. The motor bearings should be in good condition.
assets.Maintenance time regulations for hydraulic elevators: After 1500 hours of daily maintenance of the elevator, repair the mechanical and electrical systems.
It can be seen that the hydraulic lifting platform needs to carefully inspect the hydraulic and electrical systems before use so as to facilitate its use.
Remove trailing spaces, remove blank lines, remove non paragraph blank lines, punctuation correction: Leading space type: Number of spaces:
Dusseldorf.Shafts must have split pins and be sufficient.
After working for 10000 hours, repair the mechanical and electrical systems of the elevator.
Pay attention to checking each part of the steel wire rope for broken wires and loose strands. If the tide passes through the relevant regulations, it must be replaced immediately. The maintenance and upkeep of steel wire ropes should strictly follow the provisions of GB5144-85.