ToulonElectric
ToulonDecorati
ToulonElectricHorizontal lead screw mechanical electricity
Setting requirements: The landing door should be standardized and tooled.
Toulon.The impact load can cause early wear, fracture, and fragmentation of mechanical structural components, as well as generate impact pressure in the hydraulic system, which in turn can damage hydraulic components, oil seals, and high-pressure oil
Small safe operation distance: Circuit voltage (kV) of external power lines<11~1035~110220330~550 Small safe operation distance (m) 4681015 Setting requirements: A small safe distance should be maintained between the outer edge of the construction electric elevator and the edge of the external overhead power line.
.Vertical lead screw electric lifting mechanism: Adopting a lead screw transmission method,ToulonMicro electric elevator, it can achieve the lifting of a double-layer tabletop. Multiple lifting platforms can be formed as needed and different steps can be formed within the travel range to meet the needs of meetings and performances; Pavilion, Tower, Pavilion; Ideal props.
Protective measures should comply with regulatory requirements.
Setting requirements: Each landing entrance should be equipped with a landing door,Toulon200 kg electric elevator, which should cover the opening with its full width, and should not open towards the lifting passage.
The motor of the hydraulic guide rail lifting platform is set around the wellbore, occupying a relatively small area, improving the utilization rate of the wellbore area.
Non automatic reset upper and lower limit switches should be installed at both the upper and lower ends of the stroke, which should be able to cut off the power supply before the suspension cage and other mechanical stop devices (such as buffers),
Construction electric elevators should be equipped with cable guide frames and comply with regulatory requirements.
project.Mechanical devices controlled by cage movement should not be used to open or close the landing door.
The safety distance between the outer edge of the upper part of the landing door and the moving parts of the electric elevator during normal operation should not be less than 0.75m; If the rated speed is not greater than 0.7m/s, the safety distance can be 0.40m.
The scaffolding of the parking platform should be laid tightly and firmly.
The list of materials for making landing doors is as follows: Table 1: List of materials for making landing doors. Landing doors should be installed at the entrance of each landing station, and the landing doors should function properly.
Statistics.Setting requirements: The installation and dismantling workers, electricians, and other operators of construction electric elevators should have special construction operations.
The suspension cage movement can only be resumed after operator operation.
Setting requirements: When the distance between the outer edge of the construction electric elevator and the external overhead power line cannot meet the requirements of a small safety distance, soft scenery,ToulonInstallation of electric elevators for fire protection, etc. In some theaters, there is a soft scenery storage lifting platform located at an appropriate location on the stage for the storage of blankets soft scenery, etc.
Acceptance: Concrete strength grade C30, strength testing report.
It is reported that a fixed electric elevator has good lifting stability and can only be used for fixed operations, making high-altitude operations easier