Xilingol Leagu
Xilingol LeaguWhen the wall bracket adopts non matching standard products, resulting in a safety clamp. To prevent breakage of the lifting wire rope. A safety clamp that can simultaneously cut off the power supply and stop the car from falling should be removed from the car. A car without safety tongs is not allowed to ride or carry people. If it is a simple electric elevator,Xilingol LeagueElectric one ton elevator,Xilingol LeagueElectric elevator mobile type, there should be a safety device (such as a safety stop pin) to prevent people from suddenly falling when loading and unloading goods in the car; Electric elevators with three or more floors (including three floors) for passengers or passengers.
Xilingol League.The noise of aluminum alloy electric elevators during operation is relatively low. If the noise is high, it is abnormal. Therefore, it is necessary to do a good job in troubleshooting, find the cause in a timely manner, reduce noise pollution, and reduce dangerous accidents
Setting requirements: The guide rail should be rigid and flexible components such as wire ropes or chains should not be used.
.The use of standard section connecting bolts should comply with the user manual and specification requirements.
Setting requirements: The landing door should be standardized and tooled.
Later, when there is a major malfunction of the lifting platform, it should not be used again to avoid accidents, personnel and property losses.
Small safe operation distance: Circuit voltage (kV) of external power lines<11~1035~110220330~550 Small safe operation distance (m) 4681015 Setting requirements: A small safe distance should be maintained between the outer edge of the construction electric elevator and the edge of the external overhead power line.
A lifting platform with specifications ranging in height from 1 meter to 20 meters.
Horizontal lead screw mechanical electricity
Honest management.Chain type electric lifting mechanism: With a good guiding mechanism, it can ensure that the equipment does not tilt during operation. Gear and rack electric lifting mechanism: precise transmission and high cost.
The full height landing door should meet the following requirements: the net height of the landing door opening should not be less than 0m. In special circumstances, when the net height of the building entrance is less than 0m, it is allowed to lower the height of the lower door opening, but in any case, the net height of the lower door opening is not less than 8m. (Article 1 of GB26557-2011)
The quality of the standard section should comply with the product manual and specification requirements.
Emergency manual valve: In case of power failure it can cause the car to descend to the nearest floor position and open the door
Packaging strategy.From the above comparison, low noise it can be seen that hydraulic electric lifting mechanisms have stable lifting,Xilingol League2 meter micro electric lifting platform, long service life, large load bearing capacity, and are relatively simple, making them suitable for use in stage equipment.
Construction electric elevators should be equipped with upper limit switches that are sensitive and reliable.
The verticality of the guide rail frame should meet the requirements of the specifications.
Xilingol League.Double layer steel mesh: The diameter of the steel bars is 12mm, with a spacing of 200mm.
The foundation production and acceptance of electric elevators for foundation construction should comply with the user manual and regulatory requirements.
When applying a normal force of 300N to any position on either side of the door using a rigid 5000mm2 square or circular flat surface in the locked position of the landing door, the door should be able to withstand and have no deformation; - Deformation not exceeding 30mm; After the test, it worked normally.