Zhang Boli2 meter electric elevatorYield rate in production

When the door is closed, except for the gap between the lower part of the door that should not exceed 35mm, any through-hole and opening size related to the distance between any door and adjacent moving parts, as well as the gap around the door or the gap between parts, should comply with the provisions of Table 4 of GB 23821-2009.

The function of the lifting platform in a theater is roughly as follows: the main lifting platform arranged in the main performance area of the stage is mainly used to quickly change the scenery. Typically, with&quo; Product; In the music and dance theater stage arranged in a zigzag pattern, the lifting platform, side car platform, and rear car turntable perform a rapid transformation of the entire or partial scene. This arrangement allows for rapid switching of three full sets.

Zhang Boli.Do not move after lifting, and do not lift until the four legs are firmly supported.

Protective measures should comply with regulatory requirements.

.Chain type electric lifting mechanism: With a good guiding mechanism, it can ensure that the equipment does not tilt during operation. Gear and rack electric lifting mechanism: precise transmission and high cost.

During loading and unloading, the horizontal distance between the edge of the cage door and the edge of the landing station should not exceed 50mm.

Especially suitable for steel structured factories suitable for both indoor and outdoor installation.

Setting requirements: The layout and installation of all cables and wiring of electric elevators should be able to prevent mechanical damage.

If the set screw is loose, be sure to pin it tightly to prevent accidents caused by the shaft pin falling off. Hydraulic oil should be kept clean and replaced every 6 months.

The pump body adopts an integrated pump station, all equipped with imported high-quality pump stations, the landing door shall not be opened.

From the above comparison, it can be seen that hydraulic electric lifting mechanisms have stable lifting, long service life, large load bearing capacity,Zhang Boli10 meter electric elevator, and are relatively simple, making them suitable for use in stage equipment.

The net height of the landing door opening should not be less than 8m, and the difference between the net width and the outlet width of the cage door should not exceed 120mm. When the floor door is closed,Zhang BoliElectric brick elevator on construction site, except for the gap between the lower part of the door that should not exceed 35mm the size of any through-hole and opening related to the distance between any door and adjacent moving parts, as well as the gap around the door or between parts, should comply with the provisions of Table 4 of 'Mechanical Safety - Safety Distance to Prevent Upper and Lower Limbs from Touching Dangerous Areas' GB23821-2009.

Setting requirements: The wall bracket should use the manufacturer's matching standard products.

Honesty is the foundation.Setting requirements: The verticality deviation of the installation of the guide rail frame of the construction electric elevator should comply with the requirements of the user manual and specifications, as specified in the above table.

Setting requirements: A limit switch should be set at both the upper and lower ends of the stroke, which should be able to cut off the power supply before the suspension cage and other mechanical stop devices (such as buffers),Zhang BoliFour meter electric elevator, so that the suspension cage can stop

When the foundation is set on the roof or floor structure, the bearing capacity of its supporting structure should be checked.

Zhang Boli.The use of standard section connecting bolts should comply with the user manual and specification requirements.

Drainage measures need to be considered around the foundation. (Drain the accumulated water on the foundation).

Chain type electric lifting mechanism: With a good guiding mechanism, it can ensure that the equipment does not tilt during operation. Gear and rack electric lifting mechanism: precise transmission and high cost.