UtrechtElectri
UtrechtThree mUtrechtElectric hydraulic folding elevator,UtrechtMigao Electric Elevator,
The foundation base or embedded parts should be fully embedded in the concrete foundation plate.
Setting requirements: The layout and installation of all cables and wiring of electric elevators should be able to prevent mechanical damage.
Utrecht.The safety overtravel of limit switches and upper limit switches should comply with regulatory requirements.
Tank oil temperature protection: When the oil temperature in the tank exceeds the standard setting value, the oil temperature protection device sends a signal to suspend the use of the elevator. The elevator can only be started when the oil temperature drops
.Flat screw mechanical electric lifting mechanism: The lifting platform of this structure has the advantages of small civil engineering coordination, shallow foundation pit required, large stroke, stable operation, low noise, accurate positioning, and low cost. Adopting a horizontal screw drive and a scissor fork structure to achieve the lifting motion of the table, it can be stopped arbitrarily within the range of travel.
The angle between the wall bracket and the horizontal plane should comply with the requirements of the user manual.
Braking. The brake limit switch for partial motion control of the electric hoist traction machine. Assembly that restricts the operation of the lift car when it is opened to a high or low position; If the limit switch controls the overtravel switch. When the car travels to a high or low position, it will take on the function of raising or lowering. In order to prevent the lift car from crashing or sinking, stage equipment should be dismantled with over travel switches that can cut off power and cannot be automatically reset, and installed in the machine room,UtrechtElectric pull rod elevator, rather than in the shaft; A buffer should be installed that can absorb the energy of the moving mechanism and reduce impact.
When the wall bracket cannot meet the requirements of the construction site, it should be designed and calculated separately.
The installation position of the lower limit switch. The installation position of the lower limit switch should ensure that the contact plate triggers the switch when the rated load of the suspension cage decreases causing the suspension cage to stop. At this time, the number of high-rise buildings in urban areas has sharply increased the contact plate should also be close to the triggering of the lower limit switch
The use of standard section connecting bolts should comply with the user manual and specification requirements.
Quality assurance.Setting requirements: The landing door should be standardized and tooled.
Electric elevators used in various places.
With the continuous improvement of urbanization level in China, and the height of buildings has also continued to grow. This has created a demand for high-altitude lifting platform vehicles. Therefore, in order to meet the needs of the domestic market and the public, efforts will inevitably be made to design and produce high-altitude lifting platform vehicles.
Protective measures should comply with regulatory requirements.
analysis.When a rigid 5000mm2 square or circular flat surface is applied with a normal force of 600N to either side of the door, the door may not meet the above requirements, but safety should be maintained.
Pole
The spacing between wall brackets and the height of guide rails above the high attachment point should comply with the requirements of the user manual.
Utrecht.Setting requirements: The quality of the standard section should meet the requirements of the product manual. Before installing the construction electric elevator, all components should be inspected, and standard sections and other components with severe wear and deformation should be replaced.
It is understood that the scissor type lifting platform is a widely used specialized equipment for high-altitude operations. Its shear fork mechanical structure provides high stability for the lifting platform, wide working platform, and high load-bearing capacity, making the range of high-altitude operations larger and suitable for multiple people working simultaneously. The lifting power is divided into 24V, 220V or 380V power supplies, diesel engines, using Italian and domestic hydraulic pump stations, and the table top is equipped with anti slip insulation buckle plates, which have anti slip, and safety features. Please rest assured to use.
News Abstract: The development of the lifting platform industry will continue to grow in recent years! With the continuous development of electric lifting machinery for high-altitude operations in recent years, and various new technologies and materials have emerged, making the further development of lifting platform vehicles possible.