QingtianRequirements for oil immersed transformer roomWhat is the process during operation?

QingtianBox type transformer,

(II) the height width ratio of dry-type transformer pier installed on the ground is generally 0.5m,Qingtian20kV power transformer, and a guardrail of no less than 7m shall be installed around it, it is necessary to carry out voltage transformation and blood pressure reduction according to the transformer to reduce the loss of electromagnetic energy in the whole process. Therefore, the power consumption of the processing plant is all connected with 10kV switching power supply, which is converted into bottom voltage electromagnetic energy through transformer.

Power transformer manufacturer

.The iron core of power transformer is made of high-quality crystallized hot-rolled ferrite core which is stacked at the 45 degree fully inclined multi-step interface. The surface is covered with epoxy resin adhesive cable sheath coating, which is resistant to corrosion and rust, and has sound insulation and noise reduction.

In the electric field of the winding to the yoke, there must be a strong line breaking component so that sliding flash charge and discharge may occur at a lower current. In order to better solve this disadvantage, the appearance of the insulating parts between the winding and the iron yoke should be the same as that of the medium horizontal plane of the winding to the iron yoke insulation as far as possible, so as to reduce the electric field component intersecting with the insulating parts.

Method and process of taking oil sample of power transformer

The main reason is that the welding quality of electric welding is poor, there are empty welding, open welding, needle holes, sand holes and other shortcomings in welding. The oil transformer is easy to be covered with welding powder and paint when leaving the factory, and the potential safety hazards are exposed after operation. In addition, the electromagnetic induction vibration will crack the electric welding and lead to leakage.

Several detection methods for installing transformer

What is the reason for the shutdown of power transformer?

Product line.Dry type transformer manufacturer

Careless maintenance and insulation damage

Deterioration damage of transformer core insulation

Loose core screw

A complete range of products.The representative mode of connection group of dry-type transformer is: English capital letters indicate the wiring on the primary side (or primary side),QingtianOn load voltage regulation of power transformer, and English letters indicate the wiring on the secondary side (or secondary side). Y (or y) is star wiring, apart from the application of the Finance Bureau, the industry has been trying to formulate and upgrade transformer commodities according to the specifications, so as to promote the improvement of energy consumption level of transformer commodities.

Dry type transformer

Qingtian.High voltage fuse of transformer breaks one phase;

Oil leakage of porcelain pot and laminated glass oil level gauge

Dry type transformer