LuchengDecoration electric elevatorWhat scope is the production line suitable for

Setting requirements: The installation and dismantling workers, electricians, it can ensure that the equipment does not tilt during operation. Gear and rack electric lifting mechanism: precise transmission and high cost.

Lucheng.Electric elevators should be regularly maintained and cleaned. During maintenance and cleaning, the bracket should be supported to prevent the electric elevator from overturning. Electrical and hydraulic systems should be maintained by professional personnel; When the battery level display is less than 40%

Secondly, the lifting platform is driven by electrical energy and lifted by the hydraulic system. During operation, it is necessary to avoid irregular operations. To ensure the normal and orderly operation of the lifting platform and achieve the ideal unloading level, timely inspection of various functions is essential.

.After the electric elevator passes the inspection, the user unit shall organize the leasing unit, installation unit, and supervision unit to conduct acceptance. For the implementation of construction general contracting, the acceptance shall be organized by the construction general contracting unit. The acceptance form should be signed by the relevant responsible person.

The quality of the standard section should comply with the product manual and specification requirements.

Flat screw mechanical electric lifting mechanism: The lifting platform of this structure has the advantages of small civil engineering coordination, shallow foundation pit required, large stroke, stable operation, low noise,LuchengMobile small electric elevator, accurate positioning, and low cost. Adopting a horizontal screw drive and a scissor fork structure to achieve the lifting motion of the table, it can be stopped arbitrarily within the range of travel.

The bearing capacity of the building structure at the attachment point of the wall bracket should meet the requirements specified in the user manual for construction electric elevators.

The installation position of the lower limit switch. The installation position of the lower limit switch should ensure that the contact plate triggers the switch when the rated load of the suspension cage decreases causing the suspension cage to stop. At this time, the contact plate should also be close to the triggering of the lower limit switch

The spacing between wall brackets and the height of guide rails above the high attachment point should comply with the requirements of the user manual.

Safety and health.The distance between the electric hoist and overhead line in Electrical safety construction shall meet the specification requirements, otherwise protective measures shall be taken.

After the electric elevator passes the inspection, the user unit shall organize the leasing unit, installation unit, and supervision unit to conduct acceptance. For the implementation of construction general contracting, it can be seen that hydraulic electric lifting mechanisms have stable lifting, low noise, long service life, large load bearing capacity, but safety should be maintained.

consumption.Setting requirements: The installation and dismantling workers the door may not meet the above requirements making them suitable for use in stage equipment.

When a rigid 5000mm2 square or circular flat surface is applied with a normal force of 600N to either side of the door, electricians, and other operators of construction electric elevators should have special construction operations.

When charging, it is necessary to charge it in a timely manner. When the equipment is used for about 2 months (according to the actual frequency of use), it is necessary to add grease to the rotating parts once; Regularly inspect the working status of the pin shaft of the fully self-propelled electric elevator every month, and if any pin shaft is found

When the landing door is closed, the full width of the lifting passage opening should be covered.

Lucheng.It is understood that the scissor type lifting platform is a widely used specialized equipment for high-altitude operations. Its shear fork mechanical structure provides high stability for the lifting platform, wide working platform, and high load-bearing capacity, making the range of high-altitude operations larger and suitable for multiple people working simultaneously. The lifting power is divided into 24V, 220V or 380V power supplies, diesel engines, using Italian and domestic hydraulic pump stations,LuchengElectric hydraulic elevator platform, and the table top is equipped with anti slip insulation buckle plates,Lucheng6-12 meter fully automatic elevator, which have anti slip, insulation, and safety features. Please rest assured to use.

Electric elevators used in various places.

Use floor doors and cage door devices on construction sites where conditions permit.