OstrovinkaFixe
OstrovinkaElevVoltage too low: Measure the starter voltage, with an allowable fluctuation range of± 10%.
Before installation, the installation personnel should confirm the infrastructure such as the foundation and shaft, and confirm that the foundation meets the requirements before construction.
Ostrovinka.Carefully prepare a special construction plan for installation and construction and alignment points leveling, and provide safety technical disclosure to installation personnel.
Protective device: In case of power or oil circuit failure, there should be a safety rope to prevent the workbench from falling out of control. (Allow controlled descent)
.Stability: The workbench should evenly withstand 125% of the MAX load capacity and be stable at the MAX elevation.
When the hydraulic system malfunctions, the hydraulic elevator may experience problems with the hydraulic pump, motor, and hydraulic installation after repairing the hydraulic system, which can easily cause vibration and generate significant noise.
The installation personnel should have the qualification for installing hydraulic cargo elevators,OstrovinkaScissor fork hydraulic lifting table, and provide safety technical disclosure to the installation personnel for technical design.
The characteristics of the platform include reliable hydraulic system, simple operation, large load-bearing capacity, and rear hinge support.
Check valve leakage oil pipe check valve leakage. The solution is to carefully check whether the one-way valve is functioning properly. If it is not normal, it is recommended to replace the one-way valve with a new one.
Regularly inspect the hydraulic lifting equipment of the upper and lower materials to ensure the safety of the rail type elevator and the safety of the material supply to the rail type lifting platform.
Product range.The characteristics of the platform include reliable hydraulic system, simple operation,OstrovinkaHydraulic lifting table lifting, large load-bearing capacity, and rear hinge support.
Voltage too low: Measure the starter voltage, with an allowable fluctuation range of± 10%.
There is air in front of the pilot valve of the elevator overflow valve noise overflow valve. The damping hole on the main valve core of the overflow valve is blocked by oil dirt, and the pilot valve and valve seat are matched without spring deformation or incorrect installation. The remote control port has excessive oil flow, low or high hydraulic oil viscosity, and resonance occurs with components in the circuit. Troubleshooting: Strengthen sealing, repeatedly adjust the pressure, exhaust and clean the valve body several times, Make the damping hole unobstructed, repair or replace the spring, reduce the flow of the remote control port, replace the oil, and other components. The pressure setting of other components should not be similar to the pressure setting of the relief valve. 5. The noise of the elevator pipeline is usually caused by excessive dead bends or loose fixed sleeves in the hydraulic pipeline.
Oil leakage is a common malfunction. Due to loose joints or damaged sealing rings, oil leakage may occur. Therefore, this fault can be solved by tightening the oil leakage joint or replacing the damaged sealing ring.
index.The speed circuit is the circuit that switches the motion speed and speed of the actuator in the hydraulic system of the guide rail hydraulic lifting platform. Mainly including valves, pumps, and actuators. The commonly used speed circuits include speed circuits, high-speed circuits, and speed switching circuits.
All high-altitude operations must first build scaffolding or take measures to prevent teams from falling before boarding the vehicle bridge.
After 10000 hours of operation on the hydraulic lift, major repairs will be carried out to the mechanical and electrical systems.
Ostrovinka.Introduction to the unloading lifting platform: The unloading lifting platform is a specialized auxiliary equipment used in conjunction with forklifts for cargo loading and unloading. With it, forklifts can directly drive from the ground into the interior of car compartments for batch loading and unloading operations. The warehouse unloading platform products use manual hydraulic power and do not require power supply. Only one person needs to operate to achieve safe and fast loading and unloading of goods. It can reduce a lot of labor, improve the efficiency of loading and unloading operations, speed up the flow of materials, and obtain greater economic benefits.
The classification of lifting platforms is as follows: they are divided into mobile lifting platforms, automatic lifting platforms, hydraulic lifting platforms, folding arm lifting platforms, and sleeve type lifting platforms according to their different modes of movement.
When the hydraulic system malfunctions,OstrovinkaSmall hydraulic lifting and leveling, the hydraulic elevator may experience problems with the hydraulic pump, motor, valve, and hydraulic installation after repairing the hydraulic system, which can easily cause vibration and generate significant noise.