lush mountainF
lush mountainT
lush mountainLDouble layer steel mesh: The diameter of the steel bars is 12mm, with a spacing of 200mm.
The end height of the guide rail frame above the high attachment point should comply with the provisions of the user manual.
lush mountain.When adding hydraulic oil, we can extend the oil cylinder to the high position for filling. When filling,lush mountainElectric scissors elevator, the lifting platform should not exceed the high position and then retract the oil cylinder back to the low position to check if the hydraulic oil level is lower than the low position, and maintain it between the two.
Speed limiter. To prevent the driving speed from exceeding the normal speed. A speedometer should be installed (not required for floors below or including the second floor),lush mountainGuide rail electric elevator, which is an individual mechanism that is integrated with a safety clamp; The entrance and exit of the passenger compartment should be equipped with safety doors. Public places, family dormitories, and
.The function of the lifting platform in a theater is roughly as follows: the main lifting platform arranged in the main performance area of the stage is mainly used to quickly change the scenery. Typically, with&quo; Product; In the music and dance theater stage arranged in a zigzag pattern, the lifting platform, side car platform, and rear car turntable perform a rapid transformation of the entire or partial scene. This arrangement allows for rapid switching of three full sets.
The use of a lifting platform as a tool for storing performance blankets, soft scenery, etc. In some theaters, there is a soft scenery storage lifting platform located at an appropriate location on the stage for the storage of blankets soft scenery, etc.
The hydraulic oil forms a certain pressure by the vane pump, and enters the lower end of the hydraulic cylinder through an oil filter, explosion-proof electromagnetic directional valve, throttle valve, and balance valve, causing the hydraulic cylinder to move upwards and lift heavy objects. The return oil at the upper end of the hydraulic cylinder returns to the oil tank through the explosion-proof electromagnetic directional valve, and its rated pressure overflow valve is adjusted. The pressure gauge observes the reading value on the pressure gauge. The downward movement of the hydraulic cylinder (i.e. lowering of heavy objects).
Then, the lifting platform platform platform that carries the load needs to be balanced, causing oil leakage or pipe explosion. The oil temperature rises due to frequent action of the overflow valve.
When the horizontal distance between the edge of the cage and the edge of the landing or between the cage and the landing door is greater than 150mm and there is no effective protection from other structures and the lifting of goods should try to maintain a stable and uniform speed.
The pressure joint between the pipe joint and the rubber hose fails prematurely, the side protection device for the landing entrance should be equipped.
Packaging strategy.Later, when there is a major malfunction of the lifting platform, it should be repaired by professional personnel as soon as possible. After the malfunction occurs, it should not be used again to avoid accidents,lush mountainElectric elevators for construction sites, personnel and property losses.
When the landing door is closed, the full width of the lifting passage opening should be covered.
Setting requirements: The wall bracket should use the manufacturer's matching standard products.
The motor of the hydraulic guide rail lifting platform is set around the wellbore, occupying a relatively small area, improving the utilization rate of the wellbore area.
A complete range of products.Mechanical devices controlled by cage movement should not be used to open or close the landing door.
During maintenance or when problems occur, the power supply should be cut off in a timely manner. After lifting, the aluminum alloy electric elevator should be firmly fixed before maintenance can be carried out. It is strictly prohibited to operate with defects to avoid accidents.
Setting requirements: Before starting work every day and changing shifts, the driver of the construction electric elevator should inspect the construction electric elevator according to the requirements of the user manual and specifications, record the inspection results, and report any problems found to the user unit.
lush mountain.From the above comparison, low noise, long service life, large load bearing capacity, and are relatively simple, making them suitable for use in stage equipment.
The landing door should meet the requirements of the specifications and achieve standardization.
The L distance depends on the selected wall mount model.