Larosh on the 
Larosh on the The verticality of the guide rail frame should meet the requirements of the specifications.
The full height landing door should meet the following requirements: the net height of the landing door opening should not be less than 0m. In special circumstances, when the net height of the building entrance is less than 0m, it is allowed to lower the height of the lower door opening but in any case, the net height of the lower door opening is not less than 8m. (Article 1 of GB26557-2011)
Larosh on the Yonghe River.Check the starter potential when the lifting table is not raised or the voltage is too low when the motor load is working. Voltage hydraulic range allowed&
The use of a lifting platform as a tool for storing performance blankets, soft scenery, etc. In some theaters, there is a soft scenery storage lifting platform located at an appropriate location on the stage for the storage of blankets, soft scenery, etc.
.Setting requirements: For construction electric elevators with foundations installed on roof slabs, the bearing capacity of the foundation support structure should be checked. Click here to download the construction technical information for free. Basic drainage facilities should be installed.
Protective measures should comply with regulatory requirements.
Setting requirements: The spacing of wall brackets along the vertical direction should comply with the provisions of the user manual.
Monthly maintenance and inspection of hydraulic lifting platform rollers or other lower suspended structures, intermediate shafts and bearings, oil cylinder pin shafts and bearings, boom hinge shafts and bearings for wear. Add some oil to each part to extend the service life of the lifting platform bearings. The quality and level of hydraulic oil. The lifting platform should be raised throughout the entire process, the hydraulic ground should be 40-50 millimeters higher than the bottom of the box. If the hydraulic oil becomes dark, sticky, it should be replaced in a timely manner (32 # hydraulic oil). Annual maintenance and inspection of all hydraulic pipelines and joints of the lifting platform. The pipeline must not be damaged, and the joints must not be loose. All joints must be tightened. Remove and disassemble the lowering valve of the lifting platform, blow out the plunger with compressed air, then install it and reinstall it. Drain and discard the hydraulic oil, tighten the joint,Larosh on the Yonghe RiverElevator electric micro, remove the oil filter, clean it with compressed air,Larosh on the Yonghe RiverElectric elevator mobile type, and then return it to the oil tank and connect the pipeline.
The occurrence of.
The foundation base or embedded parts should be fully embedded in the concrete foundation plate.
Promise and keep promise.The function of the lifting platform in a theater is roughly as follows: the main lifting platform arranged in the main performance area of the stage is mainly used to quickly change the scenery. Typically, with&quo; Product; In the music and dance theater stage arranged in a zigzag pattern, the lifting platform, side car platform, and rear car turntable perform a rapid transformation of the entire or partial scene. This arrangement allows for rapid switching of three full sets.
Many theaters use a lifting platform as a vertical transportation tool for goods. The rear of the main stage or the end of the side stage in many theaters are equipped with a set container transportation lifting platform which is used to vertically transport items from the ground to a designated location or even the stage plane. The lifting platform of the music pool is often used for transporting movable seats, etc.
Low power consumption: When the hydraulic guide rail lifting platform descends, it is driven by the pressure generated by its own weight, greatly saving energy and reducing consumption.
The advantages and disadvantages of several commonly used electric lifting mechanisms are as follows: hydraulic electric lifting mechanisms: using hydraulic technology, smooth lifting and low noise.
How much does it cost?.The end height of the guide rail frame above the high attachment point should comply with the provisions of the user manual.
We have all purchased the aluminum alloy electric elevator equipment, which is compact and easy to carry. Many garden style hotels, hospitals, airports, and large parking lots also wear this equipment,
Implementing multiple shifts of homework should fill in and submit records according to regulations.
Larosh on the Yonghe River.Acceptance: Concrete strength grade C30, strength testing report.
The foundation base or embedded parts should be fully embedded in the concrete foundation plate.
The landing door should be in a normally closed state. Without the permission of the construction electric elevator driver, the landing door shall not be opened.